Arduino Workshop - Project 05: Push-On, Push-Off - Part 2

Hardware Required:

Arduino Uno board

LED (x2)
330 ohm (x2), 10 K ohm resistors
Pushbutton switch (N.O.)

jumper wires





Schematic:



Project Steps:


Assemble an LED and pushbutton, following the directions for project 4. Add a second LED:
Insert a second LED in the breadboard
Connect a wire between the ground and the short pin of the second LED

Read More

Arduino Workshop - Project 04: Push-On, Push-Off - Part 1

Hardware Required:

Arduino Uno board

LED (any color)

330 ohm, 10 K ohm resistor

Pushbutton switch (N.O.)

jumper wires





Schematic:




Project Steps:


Insert the LED in the breadboard
Connect a wire between the ground and the short pin of the LED

Connect a 330 ohm resistor between the D13 on the Arduino and the long-leg of the LED

Read More

Tech News: What's new in Microsoft Office 2013?

Office 2013, the next edition of Microsoft’s flagship productivity suite, is available for business customers but won’t go on sale to consumers until the first quarter of 2013.

We got a look at it and here’s what is new in Microsoft Office 2013.


Office 2013 has undergone some drastic new changes featuring a clean new interface, and is more accessible that any previous version of Office.

The

Read More

Arduino Workshop - Project 03: Servo Motor Sweep

Hardware Required:

Arduino Uno board
Servo motor
jumper wires






Schematic:




Project Steps:

Prepare the Arduino with the code (because pin D9 was in use by the LED in project 2):


Connect the Arduino unit to your computer with the USB cable

Open the Project3 sketch into the Arduino software and upload it to your module

Disconnect the USB cable

Connect

Read More