Thursday, 20 December 2012
Arduino Workshop - Project 01: Blinking LED
Posted on 09:19 by Unknown
Hardware Required:
Arduino Uno board
LED (any color)
330 ohm resistor
jumper wires
Schematic:
Note: most Arduino modules have an LED connected to D13 already. Your LED should blink at the same time it does.
Project Steps:
Insert the LED into the breadboard
Connect a wire between the ground and the short pin of the LED
Connect a 330 ohm resistor between the
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment