Friday, 28 December 2012
Arduino Workshop - Project 02: RGB LED
Posted on 14:44 by Unknown
Hardware Required:
Arduino Uno board
RGB LED
330 ohm resistors (x3)
jumper wires
Schematic:
Project Steps:
Insert the RGB LED into the breadboard
Connect a wire between the ground and the longest leg of the LED
Connect a 330 ohm resistor between each of the other three legs and rows on the breadboard
Connect a wire from D9 to the resistor on the Red LED pin
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment